Codes and Standards

Back to Contents

PART 1926 -- Safety and Health Regulations for Construction

1926.1051 - General requirements

(a)

A stairway or ladder shall be provided at all personnel points of access where there is a break in elevation of 19 inches (48 cm) or more, and no ramp, runway, sloped embankment, or personnel hoist is provided.

(a)(1)

Employees shall not use any spiral stairways that will not be a permanent part of the structure on which construction work is being performed.

(a)(2)

A double-cleated ladder or two or more separate ladders shall be provided when ladders are the only mean of access or exit from a working area for 25 or more employees, or when a ladder is to serve simultaneous two-way traffic.

(a)(3)

When a building or structure has only one point of access between levels, that point of access shall be kept clear to permit free passage of employees. When work must be performed or equipment must be used such that free passage at that point of access is restricted, a second point of access shall be provided and used.

(a)(4)

When a building or structure has two or more points of access between levels, at least one point of access shall be kept clear to permit free passage of employees.

..1926.1051(b)

(b)

Employers shall provide and install all stairway and ladder fall protection systems required by this subpart and shall comply with all other pertinent requirements of this subpart before employees begin the work that necessitates the installation and use of stairways, ladders, and their respective fall protection systems.

Back to Contents